Hi,
This is my first post to any forum.
Learning from some of the posts online, i have purchased and installed the RVC.
But now i am stuck with the rvc wiring.
There are 2 sets of wires that can with the RVC.
One is the 26 pin cable that connects to the RNS-315. and the other one is the 3 wire cable for power and signal to the RCV. (Red, Blue and Brown)
i have connected the brown wire to the ground and the red wire to the fuse box for power. That was easy.
But i am confused about the blue signal wire.
I have located the reverse light plug, which has 3 wires. Brown, Black and Yellow.(see attached photo).
The documents i have seen, and other online material say that the reverse light plug has is one brown and 2 blue/black wire, but mine is different. its brown, black and yellow. (see attached photo)
I check the brown wire, and that goes to the ground.
the black and yellow has no power untill when i put the car in reverse, both the wires, black and yellow, have 12v.
So i dont know i should connect the blue wire from the camera to the black or yellow wire.
I am going to add the photos of the whole installation once i have the RVC up and running.
Once i know where to connect the RVC blue wire and program the VCDS, i will upload the whole write up, which will help others too.
But first i need to solve the blue wire issue.
Please help me determine the correct wire.
Thanks
This is my first post to any forum.
Learning from some of the posts online, i have purchased and installed the RVC.
But now i am stuck with the rvc wiring.
There are 2 sets of wires that can with the RVC.
One is the 26 pin cable that connects to the RNS-315. and the other one is the 3 wire cable for power and signal to the RCV. (Red, Blue and Brown)
i have connected the brown wire to the ground and the red wire to the fuse box for power. That was easy.
But i am confused about the blue signal wire.
I have located the reverse light plug, which has 3 wires. Brown, Black and Yellow.(see attached photo).
The documents i have seen, and other online material say that the reverse light plug has is one brown and 2 blue/black wire, but mine is different. its brown, black and yellow. (see attached photo)
I check the brown wire, and that goes to the ground.
the black and yellow has no power untill when i put the car in reverse, both the wires, black and yellow, have 12v.
So i dont know i should connect the blue wire from the camera to the black or yellow wire.
I am going to add the photos of the whole installation once i have the RVC up and running.
Once i know where to connect the RVC blue wire and program the VCDS, i will upload the whole write up, which will help others too.
But first i need to solve the blue wire issue.
Please help me determine the correct wire.
Thanks
